Using the Quench Recycling Shower is simple.
Simply enter the shower and begin to wash your body using soap and shampoo as you normally would. Rinse off thoroughly. This should only take two to three minutes and use around 20 litres of water. Once the soapy water has disappeared down the drain, push down the drain cover and allow the reservoir to fill. The reservoir will fill with approximately four litres (one gallon) of clean temperature-controlled water. Turn the shower off.
With the press of a button, activate Quench Mode and the water will re-circulate continuously through the shower for as long as you like. The water is filtered, pressurised and heated to the temperature that is set by the user (set it as hot or cold as you desire!) at the control panel. Whether you shower for another five or 50 minutes, you won’t use any more water.
When you’re ready to finish your shower, simply pop the drain cover up (emptying the reservoir) and step out. Finally, press the sanitize–rinse cycle button and the entire system will be thoroughly sanitized and rinsed leaving the system in its original hygienic condition and ready for the next shower.